Scan the QR code to intercept the URL of App Clips, and start App Clips recently

Question

Created Nov ’20

Replies 1

Boosts 0

Participants 2

After Appclip scans the QR code and starts, it will process the Url of the QR code. After intercepting the URL parameters, it will jump to the corresponding page. Then I closed Appclip, and opened the AppClip in the recent use of the phone. At this time, once again I get the parameters above the Url of the last scan of the QR code and jump to the corresponding page, then my question is : can I not jump into the corresponding page when I open and start the AppClip in the most recent mobile phone.

Boost

Answer 1

rynning OP

Nov ’20

Not sure what you are asking.

When I open an app clip via a QR code, take a few actions in the app clip, close (not quit) the app clip, then re-open the app clip, the app clip's state will be where I left it.

Instead, if I quit the app clip (swipe up), then re-open the app clip, it will start over using the original invocation QR code.

That's the behavior I would expect. I suppose it could restart using the default invocation URL, but that's not the way it works.

0