0 Replies
      Latest reply on Mar 4, 2020 8:16 PM by signskalan
      signskalan Level 1 Level 1 (0 points)

        Hi,

         

        I have recently setup an Automator action to print any file/PDF that is dropped into a certain network drive. I am faced with one small challenge, this script does not work after a system reboot.

         

        I do not receive any error codes of sorts, the files stay put indefinitely.

         

        If I right click and go into the Folder Action Setup and untick Enable Folder Actions and re-enable them, it asks to run unprocessed files. Only then does the service run without fail until the next reboot.

         

        The question I have is:

         

        What permission do I need to apply so the system knows to trust this action forever?

         

        I have enabled the following:

         

        Accessibility: Automator, Script Editor, Terminal, Folder Actions Set-up

        Full Disk Access: Automator, Script Editor, Terminal, Folder Actions Set-up

         

        Any help is much appreciated!