cant command line tools on catalina

After trying multiple time, I still can not get command line tools installed on OS 10.15.2 (19C57).


sudo xcode-select --reset
xcode-select --install


Restarted OS couple of times, repeated steps above. Still same error:

Can’t download the software because of a network problem.


Its really a mistke to upgrade to latest macos.


Any other suggestions ?

Up vote post of saurabhgangarde Down vote post of saurabhgangarde
18k views
Posted by
saurabhgangarde
Reply
Add a Comment

Replies

So manually installed command line tools. Will close this ticket after few folks read this solution.

Posted by
saurabhgangarde
Post not yet marked as solved Up vote reply of saurabhgangarde Down vote reply of saurabhgangarde
Add a Comment
Same issue for me and i tried to install manually but i didn't find the command line tools for 10.15 version. which version did you installed ?
Posted by
Subbupalnati
Post not yet marked as solved Up vote reply of Subbupalnati Down vote reply of Subbupalnati
Add a Comment
I ran into the same issue and I was about to ask how does one manually install command line tools?

Then I searched a bit more and found where the tools are located: https://developer.apple.com/download/more/
Posted by
kdwattell
Post not yet marked as solved Up vote reply of kdwattell Down vote reply of kdwattell
Add a Comment
Manual install worked. Command line tools download from apple; https://developer.apple.com/download/more/
Posted by
3DANK3
Post not yet marked as solved Up vote reply of 3DANK3 Down vote reply of 3DANK3
Add a Comment
Just install the latest version available. I have installed "Command Line tools for Xcode 12"
Posted by
Kinglaudo
Up vote reply of Kinglaudo Down vote reply of Kinglaudo
Add a Comment
I was only able to manually install command line tools 11.5 on macos 10.15.3. FYI
Posted by
csayler
Post not yet marked as solved Up vote reply of csayler Down vote reply of csayler
Add a Comment
On MacOs Catalina, version 10.15.1, anything higher than 11.5 failed for me.
Posted by
dcrotty
Post not yet marked as solved Up vote reply of dcrotty Down vote reply of dcrotty
Add a Comment
Hi all,
I am trying to install the Arduino 2.0 beta 4 version software to upload my 3D printer marlin firmware. In doing so I have to install the command line tools and I think Xcode. I have a Macbook pro early 2011. I am using MACos 10.15.1. None of the versions of Command line tools I have tried will work on this version. Is there a version that will work?

thank You,

Johnmmg
Posted by
Jmgerard
Up vote reply of Jmgerard Down vote reply of Jmgerard
Add a Comment